Fcc Notices; Fcc-Approved Antennas (2.4 Ghz) - Digi XBee-PRO User Manual

Required FCC Label for OEM products containing the XBee S2C TH RF Module
Contains FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1.)
this device may not cause harmful interference and (2.) this device must accept any interference received,
including interference that may cause undesired operation.
Required FCC Label for OEM products containing the XBee-PRO S2C TH RF Module
Contains FCC ID: MCQ-PS2CTH
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1.)
this device may not cause harmful interference and (2.) this device must accept any interference received,
including interference that may cause undesired operation.

FCC notices

IMPORTANT: The XBee and XBee-PRO RF Modules have been certified by the FCC for use with other products
without any further certification (as per FCC section 2.1091). Modifications not expressly approved by Digi could
void the user's authority to operate the equipment.
IMPORTANT: OEMs must test final product to comply with unintentional radiators (FCC section 15.107 & 15.109)
before declaring compliance of their final product to Part 15 of the FCC Rules.
IMPORTANT: The RF module has been certified for remote and base radio applications. If the module will be
used for portable applications, the device must undergo SAR testing.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures: Re-orient or relocate the receiving antenna, Increase the separation between the equipment
and receiver, Connect equipment and receiver to outlets on different circuits, or Consult the dealer or an
experienced radio/TV technician for help.

FCC-approved antennas (2.4 GHz)

The XBee and XBee-PRO ZB RF Modules can be installed utilizing antennas and cables constructed with non-
standard connectors (RPSMA, RPTNC, etc.) An adapter cable may be necessary to attach the XBee connector to
the antenna connector.
The modules are FCC approved for fixed base station and mobile applications for the channels indicated in the
tables below. If the antenna is mounted at least 25 cm (10 in) from nearby persons, the application is considered
a mobile application. Antennas not listed in the table must be tested to comply with FCC Section 15.203 (Unique
Antenna Connectors) and Section 15.247 (Emissions).
XBee/XBee-PRO ZigBee RF Modules User Guide
ID:MCQ-S2CTH
United States FCC
213