Table of Contents
Advertisement
In both cases will be a pause of 2 seconds after each shot (p=2).
Let's now explain the above examples and see how you can modify them to
create your own preset.
The parameters passed in the url are as follows:
● The first parameter is b and refers to the button to which the preset will
be assigned. Possible values are 1, 2, and 3, because MECHA has three
numerical buttons,
these buttons of C2 controller, but you may remember that they are also
used to enter the numbers 1, 2 and 3, respectively. This parameter is
required.
● The second parameter – s – is the number of shots around; the third
parameter can be used instead.
● The third parameter is the focal length – f – and it is optional. If you
provide this parameter, the panorama will be spherical, otherwise it will
be cylindrical.
● The fourth parameter – p – is the pause after each shot, and it is optional.
The default value is 1 second.
● Starting with firmware version (1)2134, you can use h and v parameters
to specify, in degrees, the area of a partial panorama. For example:
192.168.8.1/preset?b=1&f=80&h=100&v=75
Above is the url for a partial panorama for 80 mm lens, 100° wide and 75°
tall.
For example, a url with two parameters looks like this:
192.168.8.1/preset?b=1&s=12
Now, all you have to do is replace the values in this example with the desired
values. For example, for 6 shots around:
192.168.8.1/preset?b=1&s=6
and for a full spherical panorama for a 50 mm lens (FF equiv.):
192.168.8.1/preset?b=1&f=50
MECHA C2 User's Guide v.02.5
-
+
=
,
, and
. There are no numbers displayed on
© 2021 FANOTEC
78
Advertisement
Table of Contents
