Table of Contents
Advertisement
P
● Press the
button for about 3 to 5 seconds to power on MECHA, and
wait until MECHA reaches the idle status (and the Preset (P) Menu is
shown on C2's display).
● If MECHA doesn't reach this status, then please power it off, by pressing
P
the
button 3 seconds, and contact us at mecha@nodalninja.com.
=
● Press the
button to switch to Config (C) Menu.
<
● Press the
button to select page 8.
\
● Press the
button several times, until
appears on the display, as shown in the image below.
S
● Press the
button to launch the update. Now MECHA starts scanning
the existing networks, and when it connects to the previously created
hot-spot, two beeps are heard. The UPDATE USING H-SPOT option will
update the firmware using the MECHA-UPDATE hot-spot you set.
● Now, deactivate the hot-spot, power MECHA off, then power it on.
The response shown on the display will be: "No update found!", if
!
Internet is not available for MECHA.
If you use the above option without
creating the hot-spot, the firmware
will be updated later, when the
internet will be available.
The update may take up to 5 minutes, but
it could take longer in case of slow
Internet connection.
For more details on using C2's menus,
please read
C2's Menu
Please do not turn off MECHA while updating the firmware!
!
MECHA C2 User's Guide v.02.5
Mode.
© 2021 FANOTEC
UPDATE USING H-SPOT
20
Advertisement
Table of Contents
