Table of Contents
Advertisement
To use REAL MOVE option:
○ Mark a reference point for a REAL device driven by Rotator 1 (or lower
rotator), say, on a rail.
○ Switch to DEGREES MOVE if it is not already ON.
○ Set 1.0 TUR (1 turn or 360°) for INTERVAL 3. You can use other values
if 1 TUR is not appropriate for the device used, for example it is too
small or too large.
○ Press either
with your setting), and wait until the movement is complete. Now
measure or calculate the distance the REAL device has moved from
the reference point.
P
○ Press the
and enter the value calculated or measured before. Say 100.0 for
100.0 mm.
○ Switch to REAL MOVE. Now MECHA creates a conversion factor and
will interpret all the numeric values as real values. 100.0 will be 100
mm on the REAL device wherever these numeric values are used, in
button intervals, presets, or scripts.
To go back to values interpreted as degrees, switch to DEGREES MOVE
ON.
Do the same for the Rotator 2 (or upper rotator), if needed, with i3 REAL
MOVE 2 as final adjustment.
There is no need to repeat this process unless you have changed the
REAL device type used. When DEGREES MOVE is ON, you can set the
desired value for Interval 3, and the conversion factor already created
will not change.
● STEP by STEP is ON / OFF — Press the
two options (see
● MOTOR 1 is ENABLED / DISABLED — Press the
between the two options. The lower motor will be enabled/disabled.
● MOTOR 2 is ENABLED / DISABLED — Press the
between the two options. The upper motor will be enabled/disabled.
● DISABLE / ENABLE MOTOR 1 & 2 — Press the
between the two options. Both the lower and upper motors will be
enabled/disabled.
MECHA C2 User's Guide v.02.5
>
<
=
or
then
button to exit, then navigate to i3 REAL MOVE 1 option
Shooting in Step-by-Step
© 2021 FANOTEC
for one full rotation (or according
S
button to switch between the
Mode).
S
button to switch
S
button to switch
S
button to switch
38
Advertisement
Table of Contents
