Table of Contents
Advertisement
MECHA C2 User's Guide v.02.5
13132< → SET E2 AS ROTATOR 1
Sets E2 as lower rotator.
13121< → SET P1 AS ROTATOR 1
Sets P1 as lower rotator.
23131< → SET E1 AS ROTATOR 2
Sets E1 as upper rotator.
23132< → SET E2 AS ROTATOR 2
Sets E2 as upper rotator.
23121< → SET P1 AS ROTATOR 2
Sets P1 as upper rotator.
231231231<
Factory reset. The code needs to be entered twice, as follows:
enter 231231231< and wait until the display shows "READY", then
enter 231231231< again.
P
P
The power symbol,
, flashes on the display, and the
button
needs to be short-pressed.
If a few exclamation marks are shown on the display – "!!!"– it means that
the factory file is not found, and nothing is done.
110
© 2021 FANOTEC
Advertisement
Table of Contents
