Table of Contents
Advertisement
Enable Fast Mode — Leave this checkbox checked.
Use Nodal Ninja IR Remote — Check this checkbox if you use an NN IR remote
control, and connect the receiver to the AUX port.
Double press the Nodal Ninja IR Remote Power button for power OFF — Check
this checkbox to be able to power off MECHA pressing the power button on
the remote control twice.
Use Aux Pulse, if exists — Check this checkbox if you use MECHA in
applications requiring the Aux Pulse file. Default is clear and can be ignored.
Custom Protocol on AUX Port — Allows the use of the auxiliary port for
equipment that uses a specific protocol. With common remotes, a half-press
is detected as 1A, a full press is detected as 1A1S. These are the possibilities
for a half-press:
● 045=1A executes a preset whose name starts with 045 + blank.
● -045=1A executes a preset whose name starts with 045 + blank, but in the
opposite sense of rotation.
● HS=1A – Home Set. A Home Set can also be done by pressing the power
button.
● The following uses the inverted rotation for buttons, if it is set:
○ 45.0=1A rotates MECHA 45.0° from Home position, absolute.
○ -45.0=1A rotates MECHA -45.0° from Home position, absolute.
○ ^45.0=1A rotates MECHA 45.0° from previous position, incremental.
○ ^-45.0=1A rotates MECHA -45.0° from previous position,
incremental.
● H=1A returns MECHA to Home position set by HS or by the power button.
MECHA C2 User's Guide v.02.5
© 2021 FANOTEC
64
Advertisement
Table of Contents
