Table of Contents
Advertisement
123123<
Speed calibration for the lower rotator.
The procedure takes 1 hour and is silent, the motor is not moving.
Please wait until MECHA turns OFF automatically, and don't use the web
interface during this time.
This is a one-time procedure, which you can omit if you wish, as default
factory calibration is good.
It cannot be canceled once started.
1231232<
Speed calibration for the upper rotator, similar to the code above.
Both backlash compensation and speed calibration codes can
be used only if they are absolutely necessary for your application.
Both procedures save the results automatically.
The speed calibration makes the RPM value set in the interface
as close as possible to the same calculated RPM value.
Backlash compensation is to compensate the backlash of the
gear assembly, to have a better precision for left-right
movements, like rewind to the initial position for cable
protection (in case of C1), or in case of partial panoramas and
time-lapse.
The procedure can be repeated after a longer period of time,
after gear wears.
If you hear or see a slight right-left movement when starting the
unit, a compensation is set. Otherwise, the compensation is 0, or
is not set.
3212< → FIRMWARE VERSION
Shows the firmware version on the display, then 32123< code can be
used to update the firmware, provided MECHA has Internet access, or
the Wi-Fi with Internet that MECHA was connected to before is on.
MECHA C2 User's Guide v.02.5
© 2021 FANOTEC
108
Advertisement
Table of Contents
