Table of Contents
Advertisement
32123<
Updates the firmware, if possible. To update the firmware using the
32123< code, MECHA must be in STA or AP+STA mode and connected to a
Wi-Fi with Internet access, before entering the code. Depending on
Default Mode, it may be necessary to enable temporarily STA or AP+STA at
start via buttons, then enter the 32123< code. MECHA will show on the
display "No update found" if no update was found, or "!!!" if there is no
Internet connection.
312123< → UPDATE USING H-SPOT
Update the firmware using a hot-spot with the name MECHA-UPDATE
and (default) password 87654321, which needs to be created and active
before entering the code.
312< → UPDATE
Re-updates the current firmware.
3231<
Code for testing the IR Remote. After the code is entered, MECHA will not
execute the commands received from the IR Commander's buttons.
Instead, it will only beep and show on its display the code of the button
pressed (after the button is released), and over the battery symbol in UI.
To end the test, press the power button,
2313< → CHANGE SENSE LEFT-RIGHT
Changes the sense of left/right rotation when it is done manually using
<
>
the
,
buttons.
2323< → CHANGE SENSE UP-DOWN
Changes the sense of up/down rotation when it is done manually using
\
/
the
,
buttons.
The following codes should match with the current rotators connected to
the controller.
13131< → SET E1 AS ROTATOR 1
Sets E1 as lower rotator.
MECHA C2 User's Guide v.02.5
© 2021 FANOTEC
P
.
109
Advertisement
Table of Contents
