Fanotec MECHA C2 User Manual page 39

● CHANGE SENSE LEFT-RIGHT — Press the
of left/right rotation when it is done manually using the
buttons.
● CHANGE SENSE UP-DOWN — Press the
up/down rotation when it is done manually using the
buttons.
● ARROWS speed ... RPM — Press either
mode and adjust the rotational speed when a button is held down (see
Arrow Buttons).
● INTERVAL 1/2/3 and Interval 1/2/3 speed are the angles of rotation and
corresponding speeds for
button to enter edit mode and adjust their value.
● LEVEL AMOUNT — The angle at which the upper rail is rotated after
powering on if you press the
The upper rail should be in the parked position at powering ON.
Enter edit mode using the
adjust it right after the rotation, when there is the possibility to omit the
confirmation of the change, meaning that you can press the
instead of pressing the
value is only available during the current work session, until MECHA is
powered off.
If the upper rotator has a position sensor, MECHA will use it as
reference and the rotation will be more accurate. When adjusting the
LEVEl AMOUNT:
○ X – will be shown if you are in the area of the positioning sensor
○ ! – will be shown if the sensor is not detected at leveling, which is
normal for E1, and may be necessary to disassemble and assemble
the upper rail rotated 180° in the case of E2 or P1 .
● SHOW HINTS is ON / OFF — Press the
two options. If enabled, the display will show contextual information to
help you use C2's Menus.
MECHA C2 User's Guide v.02.5
S
S
S
Simple Rotations. Press either
/
button when the display shows
+
button and adjust the LEVEL AMOUNT, or
S
button as usual. This means that the new
S
© 2021 FANOTEC
button to change the sense
<
button to change the sense of
\
and
+
or button to enter edit
S
button to switch between the
>
and
/
+
or
-+=
.
P
button
39