Table of Contents
Advertisement
+
○
The plus button of C2 is the equivalent of the
comes pre-programmed with 6 shots around. It can also be used to
enter the number 2, or long press it to execute the favorite code 2.
Other special functions: adjusting values in preset editing mode,
creating presets, accessing edit mode.
=
○
The menu button of C2 is the equivalent of the
It comes pre-programmed with 8 shots around. It can also be used to
enter the number 3. Other special functions: long press it to show the
C2's menus, switching from one menu to another.
NOTE. When we say the MECHA's buttons, or the buttons, we are
actually referring to the controller buttons.
Equivalence numbers ‒ buttons
numbers
C2 buttons
C1 buttons
<>
○
On both C1 and C2, the left and right buttons are used to
rotate the system manually to the left and to the right, respectively,
and also to specify the direction when launching a preset using the
controller buttons, as terminator for codes (similar to the Enter key).
They are navigation buttons as well.
/\
○
The up and down buttons of C2 control the up and down
movement of the upper rotator, when two rotators are used. They
are navigation buttons as well.
→ On Dual Axis Combo, the left and right buttons of the upper C1,
<>
, act as up and down buttons and control the upper
rotator.
S
○
The center button of C2 has a camera trigger function and
confirms the execution of a code or preset selected from the menu
or confirms the adjustment of values when editing a preset.
A code can be entered using the C2's buttons and can also be selected
from the C2's Config (C) menu.
MECHA C2 User's Guide v.02.5
1
2
-
+
1
2
© 2021 FANOTEC
2
button of C1. It
3
button of C1.
3
=
3
120
Advertisement
Table of Contents
