Table of Contents
Advertisement
● Default Wi-Fi is AP / STA / AP+STA / OFF — Press either
to enter edit mode and select the desired option.
● KEEP PAGE is ON / OFF — Press the
options. If enabled, the
thus will not go through all the options from all pages.
● USE NN IR is ON / OFF — Press the
options. Choose the ON option to be able to use Nodal Ninja IR Remote.
● IR REMOTE TEST — This option allows you to test the IR Remote. Press
S
the
button to start the test. During the test MECHA will not execute
the commands received from the IR Commander's buttons. Instead, it
will only beep and show on its display the code of the button pressed
(after the button is released).
● at SHOOT, OLED is ON / OFF — Press the
the two options. ON means that the display will be ON during the
exposure time, while OFF is the reverse.
● OLED TEST — This option allows you to check if the OLED works.
● ROTATOR 1 is ... — Press either
set the desired rotator as lower rotator.
● ROTATOR 2 is ... — Press either
set the desired rotator as upper rotator.
● ROT. 2 SENSOR is ENABLED / DISABLED — Press the
between the two options. If E2 or P1 have no sensor (like some
prototypes), or you do not want it to be used, then it can be disabled
with this option. Therefore, the leveling at powering on will be done
without sensor, assuming the upper rail is in the parked position.
○ If E2 or P1 is used as upper rotator with ROT.2 SENSOR ENABLED, at Set
Position in Simple Mode (or out of Menu in Advanced Mode), by
/
pressing
camera is above and near the level position, or below the level
position, down to parked.
○ If Rotator 2 sensor is DISABLED (or not supported), by pressing
then quickly
\
pressing
MECHA C2 User's Guide v.02.5
S
/
\
and
S
S
S
S
then quickly
, MECHA will level the upper rail if the
S
, MECHA will perform a 90º rotation up, and by
S
then quickly
, it will perform a 90º rotation down.
© 2021 FANOTEC
button to switch between the two
buttons will not change the page,
button to switch between the two
S
button to switch between
+
or
button to enter edit mode and
+
or
button to enter edit mode and
S
S
+
or
button
button to switch
/
40
Advertisement
Table of Contents
