Table of Contents
Advertisement
Battery min and Battery MAX — The minimum and maximum values for the
battery voltage according to the technical specifications for the batteries
you use.
For voltage values greater than zero, the battery level will be expressed as
percentage on the User Interface.
For voltage values lower than Battery min, you will see "BATTERY" shown on
the controller display, then MECHA will enter the Pause mode, if it's
running a preset.
In Pause mode, you can use the
/
position, and
In C2 configurations, you cannot power the rotators via a power
!
bank. If C2's batteries need to be changed during a shooting
session, use
bank to power the controller. Change the batteries, then remove
the power bank. To continue shooting where you left off, use the
/
button, if necessary.
Set Battery min in C Menu
Battery min can be set in C2's C (Config) Menu as well. In this case, it is
recommended to fully charge the battery before powering on MECHA,
then access this menu and adjust the value using the
Hold down the desired button to speed up the adjustment.
Why fully charge the battery before this adjustment?
MECHA C2 User's Guide v.02.5
\
button to go back to the previous position.
\
to go to the parked position, then use a power
© 2021 FANOTEC
button to go to the parked
-
+
and
buttons.
69
Advertisement
Table of Contents
