Table of Contents
Advertisement
● Then MECHA will go back to the initial position and start to slowly tilt
down and, again, wait for another press of the power button,
when the sheet of paper is out of the camera's view.
● Then MECHA will go back to the initial position, and
● the characters
seconds) for one of the
the computed preset to that particular button. To cancel the assignment,
the power button,
If MECHA is unable to compute a pattern using the feedback received from
pressing the power button (mostly caused by too small intervals), on the
display will be shown "!!!", which indicates that nothing has changed.
To execute the panorama computed by MECHA, make sure the upper rail is
in the level position, and press the button to which you have assigned the
panorama, then press either the left or right button.
MECHA C2 User's Guide v.02.5
- + ≡
are shown on the display, and MECHA waits
-
+
,
, or
P
, can be pressed instead.
© 2021 FANOTEC
=
buttons to be pressed, to assign
P
,
(15
102
Advertisement
Table of Contents
