Connecting The Sensor To The Input - Datcon DT4120 Series Operating Instructions Manual

DT4120 xx xx (PS)
Wiring plan, connecting
the input
(see also "Application
example")
Be careful the polarity of
the cables
20170324-V0

5.3. Connecting the sensor to the input

The following figure shows the wiring plan, connecting the
input:
1. Loosen terminal screws.
2. Insert the wire ends into the open terminals according to
the wiring plan.
3. Screw the terminal in.
4. Check the hold of the wires in terminals by pulling on
them firmly.
15