Table of Contents
Advertisement
DT4120 xx xx (PS)
Assign 100% to any
physical value (scaling)
Sequence of operation
Exit from the menu item After finishing settings press the MENU button to exit from
Exit from the menu
20170324-V0
32. Keep stepping by pressing the ▲ button as long as you
see this menu item:
potentiometer scaling 0%).
33. Enter the menu item by pressing the ENTER button.
34. You will see:
the left is blinking, signaling that it can be modify.
35. Pressing the ► button you can step to the nex digit.
36. Pressing the ▲ button you can increase the value of the
blinking digit:
,
,
,
,
37. When the digit on the left side is selected pressing the
▲ button the sequence is as follows:
,
,
,
,
can set any number between -9999-99999.
38. After setting exit from this menu item by pressing MENU
button. You can see
this menu item. You will see
(2. If you want to change the setting you have performed
just now, or if you just want to check what you have typed
in, continue the operation from Point 3 of the Sequence of
operations.)
(3. If you do not want to exit from the menu, as you want to
perform further settings, you may press the ▲ button to
select the desired menu items.)
Press the MENU button. First the mnemonic
then the mnemonic
With this the storing of the settings is completed. The
instrument has exited the menu and goes on with the
measurement.
(Potentiometer Scale 100% =
. on the display. The number on
,
,
,
,
,
,
,
,
,
,
on the display.
(Exit) are shown on the display.
,
, etc.
,
,
, etc. so you
.
(Save),
75
Advertisement
Table of Contents
