Connecting; Preparing The Connection - Datcon DT4120 Series Operating Instructions Manual

DT4120 xx xx (PS)
Select connecting cable
Preparing cables
20170324-V0

5. Connecting

5.1. Preparing the connection

Always observe the following safety instructions:
•
Connect or disconnect only in the complete absence of
line voltage
•
Take note the data concerning on the
overcurrent protection in installation.
•
Use only a screwdriver with appropriate head
Take note the suitability of the connecting cable
(wire cross-section, insulation, etc.).
You may use either solid conductor or flexible conductor.
In case of using flexible conductor use crimped wire end.
In case of mains connection the wire cross-section should
2
be 1.0 mm (min.).
In case of connection communication cables take note the
concerning prescriptions (www.modbus.org).
It's an important rule that the power cables and signal
cables should lead on a separate way.
Prepare the cable for the connection.
Strip approx. 8 mm insulation.
In case of using flexible cable, use crimped wire end.
13