Table of Contents
Advertisement
DT4120 xx xx (PS)
Limit output hold mode In case of basic operating mode the limit output is switching
Sequence of operations 31. Keep stepping by pressing the ▲ button as long as you
Exit from the menu item 1. After finishing the settings, press the MENU button to exit
Exit from the menu
20170324-V0
on or switching off when the conditions are exist. In limit
output hold mode the output is kept in switched state and
only by pressing ENTER button can be reset (limit signaling
acknowledge).
see this sub-menu item:
hold).
32. Enter by pressing the ENTER button.
33. By pressing ▲ button you can switch on or off the hold
mode:
•
: (Off = switched off). The limit output is working
according the display value and the limit value setting
(factory default).
•
: (Hold = hold). The limit output is switching on
according the display value and the limit value setting, but it
switching only off by pressing ENTER button (limit signaling
acknowledge).
from the menu item, and you see this:
MENU button to exit from the menu item, and you see this:
.
(2. If you want to change the setting you have done just
now, or if you just want to check what you have typed in, go
on with the operation from point 3 of the Sequence of
operations.)
(3. When you don't want to exit menu because you are
going to do other settings in other menu items press ▲
button to step to the following menu item.
Press the MENU button. First the mnemonic
then the mnemonic
With this the storing of the settings is completed. The
instrument has exited the menu and goes on with the
measurement.
(Limit1 Hold = limit 1,
(Exit) are shown on the display.
. Press the
(Save),
53
Advertisement
Table of Contents
