Datcon DT4120 Series Operating Instructions Manual page 52

High limit value
Sequence of operation
52
23. Keep stepping by pressing the ▲ button as long as you
see this sub-menu item:
1, high limit value). Here you can define a second numerical
value with which the instrument will compare the displayed
value when the selected operating mode is
 
or
value has no effect on the operation.
24. Enter by pressing the ENTER button.
25. You see this:
changed the low limit value and the value is greater than the
value of high limit than the low limit value will get the value
of high limit, so the low limit value can not be greater then
the high limit value. The digit at the left side is blinking.
26. Pressing the ► button you can select the next digit.
27. Pressing the ▲ button you can increase the value of the
blinking digit:
    
, , , ,
28. When the digit on the left side is selected pressing the
▲ button the sequence is as follows:
    
, , , ,
so you can set any number between -9999-99999.
29. After setting the limit value press MENU button to exit
from this sub-menu item and you see this:
30. If you don't want to keep the limit output in on state
(hold mode) while acknowledgement no need further
settings. For finishing the operation, go on with the steps
from the part: Exit from the menu item.


or . In other operating modes this

on the display. (If you have
    
, , , , ,
    
, , , , ,
DT4120 xx xx (PS)
(Limit1 High Limit = limit

or
, etc.
 
, , , etc.

.
20170324-V0