Connecting The Mains - Datcon DT4120 Series Operating Instructions Manual

Wiring plan, connecting
the instrument to the
mains
(see also "Application
example")
In case of DC supply the
polarity is indifferent
Wiring plan, connecting
the instrument to the
mains
(see also "Application
example")
In case of DC supply the
polarity is indifferent
14

5.2. Connecting the mains

The following figure shows the wiring plan, connecting the
DT4120 xx xx xx PS type instrument to the mains:
The following figure shows the wiring plan, connecting the
DT4120 xx xx xx type instrument to the low voltage power
supply:
1. Loosen terminal screws.
2. Insert the wire ends into the open terminals according to
the wiring plan.
3. Screw the terminal in.
4. Check the hold of the wires in terminals by pulling on
them firmly.
DT4120 xx xx (PS)
20170324-V0