Connecting; Preparing The Connection - Datcon DT4200 Operating Instructions Manual

Select connecting
cable
Preparing cables
Wiring plan, connecting
the DT4200 as a terminal
device:
(see also "Application
example")
Be careful the polarity of
the cable.
12

5. Connecting

5.1. Preparing the connection

Always observe the following safety instructions:
•
Connect or disconnect only in the complete absence of
line voltage
•
Take note the data concerning on the
overcurrent protection in installation.
•
Use only a screwdriver with appropriate head
Take note the suitability of the connecting cable
(wire cross-section, insulation, etc.).
You may use either solid conductor or flexible conductor.
In case of using flexible conductor use crimped wire end.
In case of mains connection the wire cross-section should
2
be 0.25-1.5 mm .
In case of connection communication cables take note the
concerning prescriptions (www.modbus.org).
It's an important rule that the power cables and signal
cables should lead on a separate way.
Prepare the cable for the connection.
Strip approx. 8 mm insulation.
In case of using flexible cable, use crimped wire end.
DT4200
20181113-V0