Connecting; Connecting Into The Current Loop - Datcon DT9000 Operating Instructions Manual

Wiring plan, connecting
the DT9000 as a terminal
device:
(see also "Application
example")
Be careful the polarity of
the cable.
16

5. Connecting

5.1. Connecting into the current loop

In hazardous areas you should take note of the appropriate
regulations, conformity and type approval certificates of the
DT9000 and other instruments are connecting in the
current loop (e.g. power supply, transmitter, etc.).
The connection must be carried out by trained and
authorised personnel only!
There are two different cases for the current loop to be
connected:
•
The DT9000 acts as a terminal device of the current loop.
In this case the signal comes via a pair of wires, and it
does not have to go to other devices.
The following figure shows this case:
DT9000
20171205-V2