Connecting The Mains - Datcon DT4220 E Series Operating Instructions Manual

DT4220 E
Wiring plan, connecting
the PS type instrument
to the mains
In case of DC supply the
polarity is indifferent.
20180619-V0

5.2. Connecting the mains

The following figure shows the wiring plan, connecting the a DT4220
E xx xx PS type instrument to the mains:
1. Loosen terminal screws.
2. Insert the wire ends into the open terminals according to the wiring
plan.
3. Screw the terminal in.
4. Check the hold of the wires in terminals by pulling on
them firmly.
15