Select connection
cable
Preparing cables
12
5. Connecting
5.1. Preparing the connection
Always observe the following safety instructions:
•
The connection must be carried out by trained and authorized
personnel only!
•
Connect or disconnect only in the complete absence of supply
voltage
•
You should take note the data concerning on the overcurrent
protection in installation
•
Use only a screwdriver with appropriate head.
Take note the suitability of the connecting cable
(wire cross-section, insulation, etc.).
The wire cross-section should be 0.25-1.5 mm
You may use either solid conductor or flexible conductor.
In case of using flexible conductor use crimped wire end.
For the input connection we recommended to use screened cable. It's
an important rule that the power cables and signal cables should lead
on a separate way.
Prepare the cable for the connection.
Strip approx. 8 mm insulation.
DT1102 V
2
.
20230127-V0