multivac C200 Instruction Manual page 53

Take the removed components to a separate room suitable for
wet cleaning.
Clean dismantled components manually with cleaning solution.
Only clean the Teflon tape of the sealing bar manually with a
soft cloth or a soft brush.
Thoroughly clean the inert gas nozzles.
Wait until the application time has elapsed (see instructions of
cleanser manufacturer).
Wipe with new cloth and water of drinking quality.
Inspect for dirt and cleanser residues.
If necessary, perform another manual cleaning and wipe it off.
Disinfect dismantled components with an alcohol-based disinfec-
tant.
Thoroughly disinfect the inert gas nozzles.
Wait until the application time has elapsed, see instructions of dis-
infectant manufacturer.
Clean the floor with a rubber wiper.
Dispose of the waste properly.
Apply cleanser to the floor in the low-pressure foaming procedure.
Wait until the application time has elapsed (see instructions of
cleanser manufacturer).
Rinse off the floor with water of drinking quality.
Manually clean the entire machine, including the table, with clean-
ing solution.
03.06.2014
Cleaning
Cleaning recommendations
53