Making The Selection Of Personnel; Training The Personnel; Providing Personal Protective Equipment; Avoiding Hazards - multivac C200 Instruction Manual

Info
Do NOT start up the machine, if there are visible defects or if the
machine is older than 19 years.
1.7.3

Making the selection of personnel

The operating company has to choose the personnel according to the
tasks to be carried out, see Section 1.1.1 "T
ating company has to order and authorise the personnel for the tasks
to be carried out.
Info
Trainees or other persons receiving instructions may only operate
the unit under the constant supervision of an experienced techni-
cian.
1.7.4

Training the personnel

The operating company is responsible for ensuring, that the person-
nel is trained and instructed in accordance with the tasks, which have
been assigned to them. The following measures can for example con-
tribute to the training and instruction:
• Provide an operating directive, which is comprehensible to the
personnel.
• Instruct personnel on how to handle the machine correctly.
• Make the machine instruction manual accessible to the personnel.
If necessary, order an instruction manual from the manufacturer in
the appropriate official language.
• Inform the personnel about measures for avoiding hygiene risks.
• MULTIVAC offers appropriate training courses.
1.7.5

Providing personal protective equipment

The operating company must ensure that the operators wear the re-
quired personal protective equipment (foot protection, head gear,
gloves, etc.) in accordance with the national directives which apply. In
Europe the directive 89/656/EEC specifies the minimum mandatory
requirements for the use of personal protective equipment.
1.7.6

Avoiding hazards

The operating company must check, whether there are special haz-
ards during operation, e.g. through hazardous fumes. The operating
company must undertake measures to avoid or limit the hazards.
1.7.7

Providing the installation location

The operating company is obliged to provide a suitable installation
location for the machine. The requirements for the installation location
can be obtained from the manufacturer.
03.06.2014
Obligations of the operating company
ARGET GROUP
Safety
". The oper-
15