multivac C200 Instruction Manual page 34

Start-up
Setting up the machine and starting it up
34
Unscrew the screw plug. To do so, turn the screw plug anticlock-
wise.
Fill the vacuum pump with the oil supplied up to the middle of the
oil sight glass.
– The oil level is then approximately in the middle of the oil sight
glass.
Check the oil level on the oil sight glass:
– The oil level should reach the middle of the oil sight glass.
– If oil level is under the MIN mark, add oil.
Turn the screw plug in the fill opening and screw it tight. To do so,
turn the screw plug clockwise.
Wipe off and remove any oil.
Fasten the safety guard.
03.06.2014
max.
min.