Operation; Switching On The Machine; Switching Off The Machine - multivac C200 Instruction Manual

Operation

36
4 Operation
4.1

Switching on the machine

Before switching on the machine for the first time fill the vacuum
pump with oil, see Section 7 "M
If present, open the stop-cock for the gas supply.
Connect the machine to the mains electricity at a place which is
always easily accessible.
Press the <Control On/Off> key.
– The machine control performs a self-test.
– The software version of the machine control briefly appears in
the display.
– The status display appears.
– The machine is ready for operation.
4.2

Switching off the machine

Press the <Control On/Off> key.
– The screen for performing the pump protection function ap-
pears.
If necessary, perform the pump protection function.
Close and press down the chamber lid.
– The vacuum pump runs for a set time.
– A counter counts to zero.
– The display goes out.
– The chamber lid opens automatically if it is not locked.
To cancel the pump protection function, press the <Control
On/Off> key again.
– The display goes out.
Info
The display goes out automatically after 10 s without input or with-
out closing the chamber lid.
Close chamber lid and lock it in place.
Close the stop valve for the gas supply, if part of the machine.
If required disconnect the machine from the mains electricity.
03.06.2014
".
AINTENANCE