Automatically Setting The Sensor Offset - Intec ColorCut SC5000 Series User Manual

9.5.2 Automatically Setting the Sensor Offset

The 'Auto Find' feature calibrates the offset automatically for you. This is achieved
5a
by using the PEN CALIBRATION TOOL. The pen tool is used to draw a circle shape
•
, the Vision3 ARMS sensor will then move over the
•
shape and determine the
exact centre point of the
shape. The ColorCut Pro
software then calculates the
distance the Vison3 sensor is
offset from the centre of the
cutting tool automatically.
1.
Place the Calibration Pen Tool B, in to
Tool Holder 1 C. (Normally the position
for the Blade Holder). (You can place and/or
leave the creasing tool into Tool Holder 2 D.)
2.
Set/Check the appropriate pressure for the Calibration Pen Tool .
(Not too much pressure or you may break the pen).
Check the AutoFind force pressure is set to between 200 - 320gms of pressure.
Recommended pressure is
220gms, however for very
thin paper you may wish to
reduce this.
Note: too little pressure
and the pen will not write.
3.
Load blank paper sheet(s) into the
media tray. Adjust the self centering
side guides to the edges of the media.
Ensure they are not too tight against the
side of the media.
Intec Printing Solutions - ColorCut Pro User Guide for Intec ColorCut SC5000 ................................................................................................... Page No: 52
•
•
shape, scan to locate the
5a
C
5b
B
D