Intec ColorCut SC5000 Series User Manual page 70

10.12.4 Creating TAGs (Cont.)
3
.
Select the new Media
Type ("Tags 50mm")
, Ensuring the
10c
"Tags 50mm" media
type is selected
12a
set Use Tool to Cut
tool .
12b
Set the Line Style
12d
to "Dashed Line
(Adjustable)"
Complete the Line
Style profile by
setting a Cut length
to 50mm and the
12e
Gap Length to
12f
1mm.
This will create a Material Type/Action that when assigned to a line color will provide
a 1mm Tag every 50mm.
4.
Now the Material Type has been created, you must apply the material type
for creating tags to the line you wish to contain tags. Click on
section, next to the Color GREEN
Type/Action
and assign it to the Color Green. The preview (above)
10c
to reflect the NEW material type (Tags 50mm) that you created and will show the
line with gaps every 50mm (Note: If your tags are small (such as 1mm) you may need to
make the tag slightly larger (3-5mm) to see it in the preview, then reduce it back to 1mm).
This will prevent the Green inside elements falling out of the sheet during cutting.
You could also assign the NEW "Tags 50mm" Material Type/Action it to
the Color red as well.
However, the perimeter
cut line is usually a long
cut line and a tag every
50mm may create
2a
a lot of tags - slowing
production and making
the element difficult to
easily pop out.
Therefore we
recommend you use
different colors in your
design for larger and
smaller elements when
you design your jobs. This will then enable you to use a new Material type with
less frequent tags for longer cut lines. (Detailed following).
Intec Printing Solutions - ColorCut Pro User Guide for Intec ColorCut SC5000 ................................................................................................... Page No: 70
2
, then select the NEW "Tags 50mm" Material
8i
8k
2a
8
8i
10c
11
12a
12
12e
Cut Setting
8
updates
2
8k
12b
12d
12f