Recap - Position Of Pagemarks On Your Media; Media Positioning - Intec ColorCut SC5000 Series User Manual

11.7 Recap - Position of PageMarks on your Media

PageMARKs are applied during the design stage, in your Graphics Application. .
It is important that (in section 6) you followed the recommendation to
set ColorCut Pro to place your PageMARKs relative to the PageSize
which keeps PageMARK positioning consistent across all of your designs,
we also recommend you use the same margins
frequently change settings.
The 1st PageMARK
margin you specified when applying the PageMARKs (refer to section 6 in this
manual and section 6.3

11.8 Media Positioning

The Media Positioning
when scanning for the 1st PageMARK. The Top Margin
settings should reflect the
11c
margins set under the ColorCut
Pro PageMark Prefences in your
Graphics Application (
Once set, it should not need to
be changed again (assuming you
do not frequently change the
PageMARK margins).
To prevent accidental changes,
the control is locked by default.
If you need to adjust the values
(normally only first time to match
your design positions), click the
Padlock to edit the values
Note: QR next to Mark
Intec Printing Solutions - ColorCut Pro User Guide for Intec ColorCut SC5000 ................................................................................................Page No: 83
, is located on the lead edge of your sheet at the offset/
10a
)
10c
control sets location that the SC5000 should move to,
11
above).
10c
.
11a
is an experimental feature not is use at this time.
11d
, to avoid having to
10c
10a
20mm
12.5mm
and the Left Margin
11b
11
10b
10b
10c
11a
11b
11c
11d