Table of Contents
Advertisement
11.5 Automatic Production Options
The Automatic Production section in the 'Productivity' dialogue box enables you
to change between production modes
The options are:
11.5.1 COPIES Mode
Displays a new dialogue box in
the area
, allowing you to enter
8b
the number of copies to cut.
11.5.2 SINGLE Mode
The SC5000 will load a single
sheet of media and cut/crease
the media accordingly. (Will hide
the Copies entry area.)
8b
11.5.3 CONTINUOUS Mode
Continues to cut all sheets in the
feeder until the feeder is empty.
Clicking on the drop down selection
'MODE' will allow you to select the production
option.
11.5.4 Copies Entry
When the Production 'MODE' is set to COPIES,
enter the number of copies you would like to cut
into the Copies Box
11.5.6 Error handling
Another important item to consider is what should
happen if an error is encountered. This can be
a mis-feed so the target was not read, an error
reading a QR code, or a blank sheet mixed in with
your cut jobs.
The error handling is set within the option 'When encountering an Error'
The recommended action is to BYPASS the error. When this is set and after an
error is encountered, there is a short pause then the sheet will be ejected and the
production process will continue.
The alternative option is to STOP which will halt production and leave the sheet in
the SC5000. You will need to remove the sheet and then start production again
after resolving the error.
For the most efficient and easiest production, use a combination of the options
in the Production dialogue box. i.e.
Enable Scan QR code on every sheet, Disable After Scanning Ask before cutting, Set
Productivty mode to Copies or Continuous and set When Encountering an Error to Bypass.
This will cut the number of jobs you require without requiring user intervention or stopping and will
reject/bypass any failed sheets.
Intec Printing Solutions - ColorCut Pro User Guide for Intec ColorCut SC5000 ................................................................................................Page No: 81
8
next to
8a
.
8b
.
8
8a
8b
8c
8a
8a
8b
8c
.
8c
Hide quick links:
Advertisement
Table of Contents
