Colorcut Registration - Intec ColorCut SC5000 Series User Manual

6. COLORCUT REGISTRATION PAGEMARKS
Before you design your page you need to consider that for accurate cutting each
job requires 4 Registration PageMARKs. The PageMARKs are automatically placed
on your artwork by ColorCut Pro's ADD Pagemarks option. They are placed on all 4
corners of a rectangle that is typically surrounding the cut lines.
The PageMARKs can be placed at a fixed position on the Page, or anywhere on the
page as long as it surrounds your design. Either example below can be used.
PageMARK's based on PageSize. PageMARK's based on Design size.
Fixed position of targets (PageMARKs) near page Marks around artwork.
edges to maximise cutting area. (Alternative to page size)
(Recommended for easier sheet replcement)
The first Registration PageMARK provides the origin of the job and is positioned
at the bottom left edge of the sheet The second provides scale (Y) and skew
parameters and is positioned top left in the drawing shown. The third mark provides
skew and rotation information and is positioned at the top right in the drawing shown
and the final fourth mark provides scale (X) and skew is bottom right.
Each Registration PageMARK is a 5mm x 5mm circle and should be 100% K black
with no outline.
Although you can manually draw the Registration PageMARKs on to your design,
PageMARKs do not need to be manually drawn on; ColorCut Pro will automatically
add them for you.
5mm
5mm
Intec Printing Solutions - ColorCut Pro User Guide for Intec ColorCut SC5000 ................................................................................................Page No: 22