Using 'Colorcut Pro Add; Selecting The Layer To Add - Intec ColorCut SC5000 Series User Manual

6.4 Using 'ColorCut Pro Add PageMARKs'
It is important to note, that when you activate the 'Add PageMARKs' feature from the
[File] menu, the ColorCut Pro software will examine the currently selected 'Layer' in
your graphics application and isolate all vector lines and curves on the page.
You may see an Error Message if there are artwork elements or images on the
layer selected when you launch ColorCut Pro. You can avoid this by drawing the
cutting profile and the artwork graphic on separate layers.
In this example the graphic layer is active; this drawing is ready for printing.
6.4.1 Selecting the Layer to Add PageMARKs
Ensure ONLY the vector lines you wish to cut and send to your Intec ColorCut
are on the layer selected before adding the PageMARKs using 'ColorCut Pro
Add PageMarks'. (You do NOT need to delete your artwork. It simply must be
on a separate layer ). In the example below the Cutline is selected (The artwork
layer is not selected) and the layer is ready for you to 'Add PageMARKs'.
Intec Printing Solutions - ColorCut Pro User Guide for Intec ColorCut SC5000 ................................................................................................Page No: 29
Launching ColorCut
Pro Add PageMARKs
with the artwork layer
selected will generate
an error:
kRasterArt not supported
ColorCut Pro does not
know how to interpret
the Graphics as cutting
lines.
Note: We have hidden
the Artwork layer in this
example, however you
do not need to hide the
artwork layer.
The ONLY requirement.
is that you must select
the vector/cut line
layer and there should
be no artwork/printed
elements on the layer
you wish to cut or
'AddPageMARKs' to.