Setting The Hotspot Ssid; Choosing Where To Set Speed And Force - Intec ColorCut SC5000 Series User Manual

9.7.2 Setting the HOTSPOT SSID

The connection to the Wi-Fi camera for the SC5000 is a WI-FI DIRECT connection
(it is not an external internet connection) so the SSID HotSpot name is specific
ONLY to the link to the cutter itself. The HotSpot SSID name does not need to be
changed or modified to link to your own normal internet WI-FI, and doing so will
cause the camera connection to fail. It is recommended to use the default setting
of H3.
However in larger installations with multiple ColorCut ServerStations driving
clusters of cutters, it may be necessary to change the SSID for each Server station
and the cutters connecting to it.
To change the HotSpot
SSID, Power off the
cutter.
Enter the new SSID
name ( ), and click on [OK] to exit the settings window.
7c
Now restart your Intec cutter and click on [OK] when the safety message appears.
When the cutter is ON-LINE, restart the ColorCut Pro software. During start up the
ColorCut Pro software will send down the new SSID to the Intec Cutter.
Remember to set the HOTSPOT SSID on your WINDOWS HOTSPOT to match the
new SSID name you set in ColorCut Pro (Section 3.21 (step 5 in this manual).

9.8 Choosing where to set Speed and Force

ColorCut Pro allows you to define the Speed and Force Settings for each material
type which is important especially if you wish to cut with different pressures in one
job (i.e. a high force to cut through an element and a light force to apply a score to
the element).
Alternatively large
curves may be
however complicated
shapes can be drawn using
different colored line so you can
associate a different speed for
each line. To achieve this the
speed and force settings must
be controlled by ColorCut Pro.
Ensure that the check boxes
are enable to ensure ColorCut Pro
can control your cutters speed
and force.
If you wish to ignore the Speed and Force Settings set under ColorCut Pro's options,
unchecking these boxes will stop the Speed and Force settings being sent to your
cutter. When these options are NOT checked all artwork lines being cut or creased
will be controlled by the settings shown on the LCD panel of the Cutter itself. You can
change the values by selecting the Tool directly on the LCD panel and using the Hard
keys to adjust speed or force as shown on the panel.
Intec Printing Solutions - ColorCut Pro User Guide for Intec ColorCut SC5000 ................................................................................................Page No: 57
sweeping
cut quickly
delicate
8
8