Overcut - Intec ColorCut SC5000 Series User Manual

10.13 OverCut

"OverCut"extends the cutline at the end of an object line (or curve) at the point where
the blade would normally be lifted.
This way it makes sure that the design is completely cut through. Due to a variety of
tolerances without the"OverCut" function, the cut line may not be completely closed
causing unwanted Tags on die-cut items or difficulties when weeding label media.
The default
setting for
13
Overcut is "Off"
.
13a
To Activate
OverCut, click
on the Purple
button on the
left side of
the OverCut
section and a
dialogue box
will appear
13b
asking you what
value you wish
to set OverCut
to.
13b
Intec Printing Solutions - ColorCut Pro User Guide for Intec ColorCut SC5000 ................................................................................................Page No: 73
Set the OverCut value to approx.
the width of the blade (for labels)
or approx 1mm for Card based
projects.
13
13c
1mm
13
13a
With OverCut
enabled the
blade will
overcut the
endpoint of the
object prior to
lifting
13c
NOTE: If cutting
complete shapes
and 1mm is
insufficient, it may
be necessary to
increase the value
to 2 or 3mm.
.