Table of Contents
Advertisement
9.7 Vision3 CCD Camera Live Video feed connection
ColorCut Pro uses a Vision3 high resolution CCD camera system. The Vision3
camera can scan and locate registration marks and also interpret QR codes printed
on the media. This enables ColorCut Pro to retrieve cut files associated with the
job, scan the position of PageMARK targets, calculating any scale, skew or rotation
issues with your printed artwork and then adapt your cut lines as required.
7a
The 'echo' of the video from the Vision3 camera is not required for operation and the
SC5000 will work perfectly without connecting to the camera. However tit is useful
to be able to see the PageMARK when scanning sheets and it is useful to follow the
progress of scanning and sensing QR codes, as it helps to understand any issues,
therefore we recommend enabling the 'echo' of the live video from the Vision3 sensor.
To enable ColorCut Pro to receive the live video feed, please set the Video feed
connection settings detailed following.
9.7.1 Setting IP address for Vision3 CCD Camera Live Video Echo
The Vison3 sensor 'echos' the live video feed over a WLAN connection. It will
connect to a HotSpot or Direct Wi-Fi connection broadcast using the default SSID
H3, and default Password: 12345678. Ensure you have set up a HotSpot or, Wi-Fi
Direct connection as described earlier in this manual.
In most cases it is recommended that you use the default setting (
IP address automatically) to allow ColorCut Pro to set the IP address of the
Vision3 camera after it has
connected to your HotSpot
/ Direct Wi-Fi connection.
This will take 45 sec to 2 mins the first time you launch the software each day.
However if you have multiple cutters or despite seeing the IP address in your
HotSpot Wi-Fi Direct connection, the ColorCut Pro software can not connect to
your cutter, then you can manually enter the IP address for the cutter (shown in
your Wi-Fi HotSpot connection list or Wi-Fi Direct connection list
Intec Printing Solutions - ColorCut Pro User Guide for Intec ColorCut SC5000 ................................................................................................... Page No: 56
7a
The Vison3 sensor is directly
connected to the SC5000
cutter's control board and the
image manipulation and results
are all are calculated internally
on the cutter.
However the Vision3 sensor
also 'echoes' a copy of the live
video feed from the camera
providing a video feedback for
the user to follow the progress
within their ColorCut Pro
application.
Obtain
7a
7b
7b
Hide quick links:
Advertisement
Table of Contents
