Launching Colorcut Pro (Direct Mode) - Intec ColorCut SC5000 Series User Manual

8.2 Launching ColorCut Pro (Direct Mode)

After selecting the layer you wish to send to the Intec ColorCut SC5000 Cutter, select
ColorCut Pro from the File menu. Both Adobe Illustrator and CorelDRAW can be
seen below with the Cutline selected and then ColorCut Pro selected from the [FILE]
menu.
Adobe Illustrator
The ColorCut Pro
splash screen will briefly
appear, then the main
ColorCut Pro application
will be displayed.
You will see
a preview of
the cutting
profile from the
CURRENTLY
SELECTED
LAYER in the
window in front of
you.
During installation you should have selected the cutter you wish
to use. If the main ColorCut Pro screen does not look like the one
shown above, follow the instructions on the next page to set the
correct customisation of ColorCut Pro to match your cutter.
Intec Printing Solutions - ColorCut Pro User Guide for Intec ColorCut SC5000 ................................................................................................Page No: 38
CorelDRAW