9.3 Output Device
This setting shows the current output device connected. When the Intec ColorCut
SC5000 is connected this should read "USB Printing Support:x" where 'x' is your
cutter type (If it is ON-LINE).
3
If the Intec ColorCut Pro software cannot sense an Intec ColorCut SC5000 cutter on
the USB connection of your computer, then this will show: "File Output".
In such circumstances, check your connection to your computer and power cycle
your Intec ColurCut SC5000 cutter. (Ensure it is off for 45 seconds to enable the
USB cache to flush).
9.4 Device Type
This setting shows the current output type of Intec Cutter connected. The main screen
and controls for ColorCut Pro will change based upon the Device type selected and
not all features will be available as detailed in this manual unless you have selected the
cutter type to match your Intec Model.
4
For the SC5000 X-Axis sheet cutter with an auto-feeder, set the cutter type to 'SC5000'.
Intec Printing Solutions - ColorCut Pro User Guide for Intec ColorCut SC5000 ................................................................................................... Page No: 50