Table of Contents
Advertisement
3.5.2 Calibration of the Sensor Offset to the Cutting Blade
The Intec ColorCut FB550 Flatbed engine includes a Vision2 - ARMS system (AutoMatic
Registration Mark Sensor).
automatically detect Registration marks, enabling accurate positioning and so ColorCut
Pro can adapt cutting lines to compensate for any scale or skew errors.
The Vision2 ARMS sensor is mounted in a different position to the centre of your cutting
blade. To cut accurately you must calibrate the distance the Sensor is of fset from the
cutting blade (Calibrating the Sensor offset) using the ColorCut Pro software application.
NOTE: The sensor offset value is stored within the software application, so you change
computers or re-install your computer, you will need to perform the calibration again.
To make calibration easy, ColorCut Pro can automatically perform the
calibration for you using the PEN CALIBRA TION TOOL. The pen tool
is used to draw lines that ar e used to define the cent e point of the
cutter blade, then the Vision2 ARMS sensor r eads these back and the
software calculates the offset automatically for you.
1.
Place the Calibration Pen Tool
C
Holder 1
Blade Holder). Then place the cr easing tool
into Tool Holder 2
3.
Press the MOVE/
along the bottom of the display.
Using the Left / Right keys move
the carriage so that you can place
a sheet of paper on the cutting
bed.
Intec Printing Solutions - Manual for ColorCut flat bed series FB550 ..................................................................................... Page No: 34
The Vision2 ARMS system uses an optical sensor to
. (Normally the position for the
D
.
Tab icon
B
. Into T ool
D
2.
Set the appr opriate pressure for the
Calibration Pen Tool.
Not too much pressure or you may break the pen
Press the 'touch-screen' panel on
TOOL1.
Use the UP / DOWN keys to set the
speed. (to 600mm/s))
Use the Left / Right keys to set the Force.
(to 280 g)
The press the [ENTER] key to accept.
B
C
.
Hide quick links:
Advertisement
Table of Contents
