Mechanical Components; Squeegee - HAKO Scrubmaster B175 R Series Manual

7. Mechanical components

7.1 Squeegee

Squeegee connection
Installation note:
1. Hook squeegee connection into chassis.
2. Align parallel to floor and tighten bolts.
Squeegee connection default setting:
1. For default setting of adjusting bushing see figure 7.1 (dimensions 9 and 8 mm).
2. Screw on the squeegee which is intended for the machine and align via the
adjusting bushing so that the sealing strips are vertical against the floor (lift slightly
and allow to fall).
3. Align castors using the method shown and adjust them so that they are 7 mm
above the ground.
4. If necessary, adjust the squeegee inclination to the ground conditions.
Sheet 71