Taking Into Operation; Working With The Hakomatic B 650 R; Detergents; Driving With The Hakomatic B 650 R - HAKO Hakomatic B 650 R Instruction Manual

5. Taking into operation

5.1 Working with the
Hakomatic B 650 R
The driver has to read this manual ca-
refully. The control elements are re-
presented by comprehensible symbols
and facilitate familiarisation.
Proceed to the first driving trails on a
clear training ground until the driver is
acquainted with the elements and their
functions.
Comply with the following
instructions:
When using the Hakomatic B 650 R,
the safety instructions generally appli-
cable for using self-propelled working
machines have to be complied with.
Transporting persons on the Hakoma-
tic B 650 R is strictly prohibited. The
warning and instruction plates atta-
ched to the Hakomatic give important
advice about safe operation. Comply-
ing with the instructions is of essence
for your safety.
Before starting to work, check the
Hakomatic B 650 R and its working
implements for their proper and safe
condition. Do not operate the
Hakomatic B 650 R without the protec-
tions being installed.

5.2 Detergents

Important note:
Use detergents suitable for automatic
machines (low foaming only). We
recommend our detergents for clea-
ning and care, which are perfectly
adapted for use in the
Hakomatic B 650 R. These products
comply with the provisions of the
Detergents Act (WMRG applicable in
Germany). Comply with the instruc-
tions for correct dosage of detergent.
Occurrence of great quantities of foam
will affect the performance of your
machine. Actually, it indicates excessi-
ve dosage or improper suitability of
dosing and degree of soiling. Unused
detergent particles lead to formation of
foam. Take the manufacturer's recom-
mendations as a first basis.
Test made by yourself in practise will
help you find the ideal type of deter-
gent and the perfect dosage applica-
ble to it.
Correct dosage will help you save
money and protect the environment.
5.3 Driving with the
Hakomatic B 650 R

5.3.1 Starting

Disconnect battery and charger unit
and connect battery with machine or
unplug mains cable and store in cable
case.
Before connecting battery plug
and machine switch key switch
off.
The driver has to be seated.
Note: The machine is equipped with
a safety circuit via the seat contact
switch.
If the operator lefts the seat (for ap-
prox. 2 sec.) the power supply is inter-
rupted. If the operator sits down again
he may restarting after setting the di-
rection selector (III/C) or the accelera-
tor pedal (V/2) to neutral then re-select
direction.
17