Rear Drive Module; Removing The 4 X 2.5-Inch Rear Drive Module - Dell EMC Core XC750 Installation And Service Manual

Figure 52. Installing a drive into the drive carrier
Next steps
1. Install the drive carrier.

Rear drive module

Removing the 4 x 2.5-inch rear drive module

Prerequisites
1. If required, Remove the air
2. Remove the drives.
NOTE: If the BOSS S2 module is installed, be sure to disconnect the BOSS S2 power cable and signal cable before
removing the 4 x 2.5-inch rear drive module.
3. If installed, Remove the BOSS S2
4. Disconnect the cables from the rear drive module.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws that secures the rear drive module to the system.
2. Lift the rear drive module from the system.
shroud.
module.
Installing and removing system components 57