Rear Drive Module; Removing The Rear Drive Module - Dell PowerEdge HS5620 Installation And Service Manual

Figure 110. Installing the front mounting front PERC module
Next steps
1. Install the system cover.
2. Follow the procedure listed in

Rear drive module

Removing the rear drive module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
4. Remove the cooling fan
5. Disconnect the signal and power cables connected to the rear drive module.
NOTE: The 2 x 2.5-inch rear drive module can be installed only with 12 x 3.5-inch backplane configuration system.
Steps
1. Loosen the captive screw using Phillips #2 screw driver.
2. Slide the rear drive towards the PIB to unlock it from the system.
144 Installing and removing system components
After working inside the
Safety instructions.
Before working inside your
cage.
system.
system.