Mounting The Remote Interface Controller (Wired) - Wine Guardian Sentinel Series Installation, Operation And Maintenance Manual

Mounting the Remote Interface Controller (Wired)

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
35
1. Disconnect the communication cable from the side
of
the Wine Guardian unit and the remote interface
controller. (Fig. 1)
a. Route the communication cable within the
wall
and/or ceiling structure of the wine cellar to
the desired controller mounting location.
b. Plan on mounting the remote interface
controller on a solid surface away from doors,
corners, air outlets, drafts or heat generating
equipment. Do not mount the remote interface
controller directly on an outside wall, a wall
adjacent to a boiler room, or other hot area.
Use a piece of foam insulation behind the
sensor to insulate it from a hot or cold surface.
The recommended height is four to five feet
above the finished floor.
2. Remove the back plate of the controller (Fig. 2) by
removing two (2) screws that hold it in place on the
remote interface. Place the back plate against the
wall and mark the location of the two mounting
points (Fig. 3). Also mark the location of the
penetration for the communication cable as this area
will require sufficient clearance for the cable to exit
the wall and attach to the back of the controller.
3. Drill two one-eighth inch holes and insert anchors at the
marked locations. Anchors may not be required if
securing to a wall stud or racking system. Insert the
screws into the holes and test fit the backing plate to
ensure it mounts easily onto the two screws and slides
down onto the slotted opening freely (Fig. 4).
4. Re-install plastic face plate on to backing plate.
5. Plug in the communication cable to the back of the
remote interface controller backing plate. (Fig. 5)
a. If using multiple Remote Interfaces either connect
each Sensor to each other in series using RJ9
cable or purchase a RJ9 Splitter to be used on
the unit.
6. Attach the Controller to the wall
7. Re-attach the communication cable to the side of the
Wine Guardian cooling unit.