Mounting The Optional Remote Interface Controller (Wired) - Wine Guardian TTW018 Installation, Operation And Maintenance Manual

Through-the-wall wine cellar cooling systems
Table of Contents

Advertisement

Mounting the Optional Remote Interface Controller (Wired)

Fig. 1
Fig. 2
Fig. 3
Fig. 4
42
Fig. 5
1. Disconnect the communication cable from
the Wine Guardian unit and the remote interface
controller. (Fig. 1)
a. Route the communication cable within the wall
and/or ceiling structure of the wine cellar to the
desired controller mounting location.
b. Plan on mounting the remote interface controller
on a solid surface away from doors, corners, air
outlets, drafts or heat generating equipment. Do not
mount the remote interface controller directly on an
outside wall, a wall adjacent to a boiler room, or
other hot area. Use a piece of foam insulation
behind the sensor to insulate it from a hot or cold
surface. The recommended height is four to five
feet above the finished floor.
2. Remove the back plate of the controller (Fig. 2) by
removing two (2) screws that hold it in place on the
remote interface. Place the back plate against the wall and
mark the location of the two mounting points (Fig. 3).
Also mark the location of the penetration for the
communication cable as this area will require sufficient
clearance for the cable to exit the wall and attach to the
back of the controller.
3. Drill two one-eighth inch holes and insert anchors at the
marked locations. Anchors may not be required if
securing to a wall stud or racking system. Insert the
screws into the holes and test fit the backing plate to
ensure it mounts easily onto the two screws and slides
down onto the slotted opening freely (Fig. 4).
4. Re-install plastic face plate on to backing plate.
5. Plug in the communication cable to the back of the
remote interface controller backing plate. (Fig. 5)
a. If using multiple Remote Interfaces either connect
each Sensor to each other in series using RJ-9
cable or purchase a RJ-9 Splitter to be used on the
unit.
6. Attach the Controller to the wall
7. Re-attach the communication cable to the back of the
Wine Guardian cooling unit.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ttw009Ttw009hWg15Wg25Wg25h

Table of Contents