Installing The Thermostat And Communication Cable; Mounting The Optional Remote Interface Controller - Wine Guardian WG15 Installation, Operation And Maintenance Manual

Installing the Thermostat and
Communication Cable
Local Interface Controller
wine cellar conditions from outside of the wine cellar or from another room in the home or
building through the use of our Remote Interface Controller.
See below for remote sensing and Optional Remote
Controller

Mounting the Optional Remote Interface Controller

Fig. 1
24
The Wine Guardian Local Interface Controller is a
combination temperature and humidity controller with
single stage cooling, heating and humidifier control. Each
Wine Guardian Through-the-Wall unit is supplied with a
Local Interface Controller as an integral component of its
assembly. It is installed at the factory and tested prior to
shipment.
In most applications the Local Interface Controller is
adequate for proper wine cellar monitoring and control.
However, sometimes multiple points of sensing and
especially for odd-shaped rooms. The Wine Guardian
Remote Sensors offer the ability to sense a maximum of
three locations and control to their average condition.
Wine Guardian also offers the option of monitoring the
Interface Controller installation details.
1. Disconnect the communication cable from the back of
Remote Interface Controller. (Fig. 1)
a) Install the communication cable within the wall
and/or ceiling structure of the wine cellar to the
desired controller mounting location.
b) Mount the remote interface controller on a solid
surface away from doors, corners, air outlets, drafts or
heat generating equipment. Do not mount the Remote
Interface Controller directly on an outside wall or wall
adjacent to a boiler room.
control are ideal,