Installing The Thermostat And Communication Cable; Mounting The Remote Interface Controller - Wine Guardian D050 Installation, Operation And Maintenance Manual

Installing the Thermostat and Communication Cable

mounted outside of the wine cellar, a remote sensor kit must be purchased and installed within the
wine cellar. See below for remote sensor installation details.
Wine Guardian units are supplied with 50 feet of Cat 3, 6-wire twisted pair communication cable
with RJ-11 connectors. Failure to use this type of communication cable WILL cause product
Installation instructions should be followed CAREFULLY as improper splicing and/or joining of

Mounting the Remote Interface Controller

Fig. 1
The Wine Guardian Remote Interface Controller is a
combination temperature and humidity controller with
single stage cooling, heating and humidifier control. Each
Wine Guardian unit is supplied with a remote interface
controller and 50 feet of communication cable. It is wired
at the factory for testing prior to shipment.
In most applications the remote interface controller will be
mounted within the wine cellar. The remote interface
controller can also be mounted directly outside of the wine
cellar or in any other room of the home or building. When
IMPORTANT
damage and WILL void any equipment warranty.
twisted pair cables can cause equipment
1. Disconnect the communication cable from the side of
the Wine Guardian unit and the remote interface
controller.
a) Install the communication cable within the wall
and/or ceiling structure of the wine cellar to the
desired controller mounting location.
b) Mount the remote interface controller on a solid
surface away from doors, corners, air outlets, drafts or
heat generating equipment. Do not mount the remote
interface controller directly on an outside wall or wall
adjacent to a boiler room.
failure.
31