Installation Of The Wine Guardian Remote Sensor; Mounting The Wired Remote Sensor (Wired) - Wine Guardian Sentinel Series Installation, Operation And Maintenance Manual

Installation of the Wine Guardian Remote Sensor

Mounting the Wired Remote Sensor (Wired)

37
The wireless remote sensor is a combination temperature and humidity
sensor only. It is designed to be mounted within the wine cellar and can be
used in combination with the remote interface controller or up to two
additional remote sensors to read and control multiple areas within the
wine cellar.
For a wired application you will require a RJ-9 communication cable.
1. Disconnect the communication cable from the side of
2. Plan on mounting the remote sensor on a solid surface
Fig. 1
3. Remove the remote sensor's face plate (Fig. 1) and
Fig. 2
the Wine Guardian unit and the remote sensor. Route
the communication cable within the wall and/or ceiling
structure of the wine cellar to the desired controller
mounting location.
away from doors, corners, air outlets, drafts or heat
generating equipment. Do not mount the remote sensor
directly on an outside wall, a wall adjacent to a boiler
room, or other hot area. Use a piece of foam insulation
behind the sensor to insulate it from a hot or cold
surface. The recommended height is four to five feet
above the finished floor.
mark the mounting points at the desired location within
the wine cellar (Fig. 2). Also, mark the location of the
communication cable connection as this area will
require sufficient clearance, for the cable to exit the wall
and attach to the back of the sensor.