Installing The Thermostat And Communication Cable; Mounting The Optional Remote Interface Controller - Wine Guardian Through-the-Wall Installation, Operation And Maintenance Manual

Installing the Thermostat and
Communication Cable
Local Interface Controller
Optional Remote Interface

Mounting the Optional Remote Interface Controller

The Wine Guardian Local Interface Controller is a
combination temperature and humidity controller with
single stage cooling, heating and humidifier control.
Each Wine Guardian Through-the-Wall unit is supplied
with a Local Interface Controller as an integral
component of its assembly. It is installed at the factory
and tested prior to shipment.
In most applications the Local Interface Controller is
adequate for proper wine cellar monitoring and control.
However, sometimes multiple points of sensing and
control are ideal, especially for odd shaped rooms.
Wine Guardian Remote Sensors offer the ability to
sense a maximum of three locations and control to their
average condition.
Wine Guardian also offers the option of monitoring the
wine cellar conditions from outside of the wine cellar
or from another room in the home or building through
the use of our Remote Interface Controller.
See below for remote sensing and Remote Interface
Control installation details.
Controller
1. Disconnect the communication cable from the back of
Remote Interface Controller. (Fig. 1)
a) Install the communication cable within the wall
b) Mount the remote interface controller on a solid
and/or ceiling structure of the wine cellar to the
desired controller mounting location.
surface away from doors, corners, air outlets, drafts or
heat generating equipment. Do not mount the Remote
Interface Controller directly on an outside wall or wall
adjacent to a boiler room.
27