Port Setup - ZyXEL Communications GS1350 Series User Manual

Network Proxy Configuration Application
Fig ure 75
As of this writing, this setting only allows communication between the Switch and the NCC.
Basic Setting > IP Setup > IP Configuration > Network Proxy Configuration
Fig ure 76
The following table describes the labels in this screen.
Table 31 Basic Setting > IP Setup > IP Configuration > Network Proxy Configuration
L ABEL
Active
Server
Port
Authentication
Username
Password
Apply
Cancel
8.7 Po rt Se tup
Use this screen to configure Switch port settings. Click
to display the configuration screen.
Chapter 8 Basic Setting
DESC RIPT IO N
Select this option to enable communication between the Switch and NCC through a proxy
server.
Enter the IP address (dotted decimal notation) or host name of the proxy server. When entering
the host name, up to 128 alphanumeric characters are allowed for the
characters inside the square quotes [~!@#$%^&*()_+{}|:"<>?-=[]\;',./']
Enter the port number of the proxy server (1 – 65535).
Select this option to enable proxy server authentication using a
Enter a login user name from the proxy server administrator. Up to 32 alphanumeric characters
are allowed for the
Use rna m e
[~!@#$%^&*()_+{}|:"<>?-=[]\;',./'].
Enter a login password from the proxy server administrator. Up to 32 alphanumeric characters
are allowed for the
Pa sswo rd
[~!@#$%^&*()_+{}|:"<>?-=[]\;',./'].
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
your changes to the non-volatile memory when you are done configuring.
Click to reset the fields to your previous configuration.
C a nc e l
GS1350 Series User's Guide
including special characters inside the square quotes
including special characters inside the square quotes
link on the top navigation panel to save
Sa ve
>
Ba sic Se tting
99
including special
Se rve r
and
Use rna m e Pa sswo rd
in the navigation panel
Po rt Se tup
.